یک رویکرد مدل سازی حرارتی کارآمد از روند جوش خطی اصطکاک

Numerical models used to simulate LFW rely on the modelling of the oscillations to generate heat. As a consequence, simulations are time consuming, making analysis of 3D geometries difficult. To address this, a model was developed of a Ti–6Al–4V LFW that applied the weld heat at the interface and ignored the material deformation and expulsion which was captured by sequentially removing row of elements. The model captured the experimental trends and showed that the maximum interface temperature was achieved when a burn-off rate of between 2 and 3 mm/s occurred. Moreover, the models showed that the interface temperature is reduced when a weld is produced with a higher pressure and when the workpieces are oscillated along the shorter of the two interface dimensions. This modelling approach provides a computationally efficient foundation for subsequent residual stress modelling, which is of interest to end users of the process.