تغذیه با فشرده سازی خنک کننده با دقت بالا و بهبود انتقال حرارت

A new cooling method of ethanol direct-contact phase-change immersion cooling was proposed in the thermal management of high power light emitting diodes (LED) and the feasibility of this cooling method was investigated. The heat generated by LED was measured firstly using two types of power systems: DC power and LED driver. Then the heat dissipation performance was evaluated under different experimental conditions. The results indicate that startup process of the cooling system is quick and only 450 s is needed to reach steady-state under heat load of 42.78 W. The minimum thermal resistance of 1.233 °C/W is obtained when liquid filling ratio is 33.14%. The junction temperature of LED under different absolute pressures is much lower than the limited value of 120 °C. Baffle with total height of 140 mm, bottom space height of 20 mm and distance away from substrate surface of LED of 8 mm improves heat transfer performance best due to ethanol self-circulating in the cooling receiver. Overall, the ethanol phase-change immersion cooling is an effective way to make sure high power LED work reliably and high efficiently.