رطوبت سطح و معیارهای طراحی گرافیتی کامپوزیت های متخلخل برنز در کاربردهای کشویی خشک

Sintered bronze with the addition of graphite as self lubricant is widely used in sliding bearings and bushes applications, especially where grease and oil lubricant cannot be considered. Aim of this work is to study the dry sliding wear behavior of a porous sintered bronze–graphite composite, which is characterized by a transition from solid lubrication to adhesive wear. In this last condition graphite loses its efficiency as solid lubricant due to the frictional heat. The efficiency of the solid lubrication was examined at different loads and sliding velocities; it decreases on increasing both load and velocity. The behavior in the different dry sliding conditions was investigated and the corresponding flash temperature was calculated. Results indicate that transition occurs when the flash temperature reaches at least 360 K. Some design guidelines were then proposed, based on a P0 vs. v map, which defines the parameters ensuring both that no plastic deformation occurs and that solid lubrication is efficient during dry sliding. The relative design scheme gives a tool to verify if the dimensional and geometrical characteristics of the part are guaranteed during its expected life.